Page 1 of 1

output interpretation

Posted: Mon May 10, 2021 4:32 pm
by nmrworker
I just installed the stand-alone i-tasser 5.1 on FC 25 and finished the 1st peptide structure prediction. However, I don't know which files to look at, eg, which file corresponds to the "Predicted Secondary Structure", "Top 10 templates used by I-TASSER", "Top 5 Models predicted by I-TASSER", etc., because I can't easily tell by the output filenames. Also does the predicted structure contains all the protons? If not, is there an option to include them?

Thanks in advance.

Re: output interpretation

Posted: Tue May 11, 2021 12:30 am
by xiaogenz
The predicted secondary structure can be found in "seq.psi.ss" and "seq.pss.ss". Top ranked templates used by I-TASSER can be found in "init.dat". "Top 5 Models predicted by I-TASSER" named as "REF_mode1.pdb" or "model1.pdb". The final model includes all atoms.

Re: output interpretation

Posted: Mon May 17, 2021 5:24 pm
by nmrworker
the "model1.pdb" generated by stand-alone version has ONLY the amide proton, but the one generated by the online server has all the protons. How to set the stand-alone version to generate all the protons?

Re: output interpretation

Posted: Mon May 24, 2021 9:31 pm
by ITASSERteam
you can download and run HAAD program (https://zhanglab.ccmb.med.umich.edu/HAAD/) to add all protons. It is very simple and fast.

Re: output interpretation

Posted: Wed May 26, 2021 3:53 pm
by nmrworker
Is that how the online service add protons to the structure? Also the sidechain orientations from the stand-alone version is quite different than the online version. Is that normal?

Re: output interpretation

Posted: Thu May 27, 2021 2:00 pm
by robpearc
1) No, as the standalone package uses Modrefiner to refine the protein conformation, while the online server uses a combination of several programs to perform the refinement. However, you may uncomment line 15 in the EMrefinement.pl included in the I-TASSER package, which will add hydrogens via HAAD.

2) Yes, the side-chain orientations may be different due to the use of 3rd party programs that we cannot include the downloadable version of I-TASSER.

Re: output interpretation

Posted: Thu May 27, 2021 3:42 pm
by nmrworker
It seems that you would recommend the online version over the stand-alone version since multiple programs are involved to improve the final results, is that right?

Re: output interpretation

Posted: Thu May 27, 2021 6:30 pm
by robpearc
Depending on your target, the results may be slightly better for the web server as it includes a few more threading methods that aren't included in the downloadable version. This will influence the results for more distantly homologous threading targets, where it is difficult to identify suitable templates from the PDB. However, for homology modeling, where there are obvious homologous templates, the results should be quite similar. In terms of the side-chain orientations, I would recommend you use our recently developed side-chain packing method, https://zhanglab.dcmb.med.umich.edu/FASPR/ to quickly repack the side-chains of your model, which was developed after the release of our latest I-TASSER package, so it wasn't included in it.